lemon-mirror:
Home >> Jeep >> 2003 >> Grand Cherokee Overland >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Junction Block >> Installation

Junction Block: Installation

NOTE: If the Junction Block (JB) is being replaced with a new unit, be certain to transfer each of the optional fuses, circuit breakers and relays from the faulty JB to the proper cavities of the replacement JB. Refer to JUNCTION BLOCK  for the location of complete circuit diagrams and cavity assignments for the JB, The Body Control Module (BCM) must also be transferred to the new JB. .
  1. Position the JB into its mounting location on the instrument panel steering column support bracket.
  2. Align the snap clips at the top of the JB with the mounting holes in the instrument panel steering column support bracket.
  3. Grasp the bottom of the JB firmly with both hands and push it upward sharply to engage the two snap clips that secure the top of the JB to the instrument panel steering column support bracket.
  4. Install and tighten the two screws that secure the JB to the instrument panel steering column support bracket. Tighten the screws to 2.2 N.m (20 in. lbs.).
  5. Reconnect the right and left body wire harness bulkhead connectors to the connector receptacles located near the center of the JB.
  6. Install and tighten the screws that secure the right and left body wire harness bulkhead connectors to the connector receptacles located near the center of the JB. Tighten the screws to 2.2 N.m (20 in. lbs.).
  7. Reconnect the fused B(+) and the IOD wire harness connectors to the connector receptacles located near the bottom of the JB.
  8. Reach behind the JB to reconnect the instrument panel wire harness bulkhead connector to the connector receptacle located near the top of the JB.
  9. Install and tighten the screw that secures the instrument panel wire harness bulkhead connector to the connector receptacle located near the top of the JB. Tighten the screw to 2.2 N.m (20 in. lbs.).
  10. Reach behind the JB to reconnect the two instrument panel wire harness connectors to the BCM connector receptacles located near the bottom of the JB.
  11. Install the steering column opening cover onto the instrument panel.
  12. Install the fuse cover onto the bottom of the JB.
  13. Reconnect the battery negative cable.
· About lemon-mirror