lemon-mirror:
Home >> Jeep >> 2004 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Fuse Block >> Installation

Fuse Block: Installation

The fuse block module is serviced as a unit with the body wire harness. If any internal circuit of the fuse block module or if the fuse block module housing is faulty or damaged, the entire fuse block module and the body wire harness unit must be replaced.

NOTE: If the fuse block module is being replaced with a new unit, be certain to transfer each of the fuses from the faulty fuse block module to the proper cavities of the replacement fuse block module. Refer to appropriate wiring diagrams for the location of complete fuse block module circuit diagrams and cavity assignments.
  1. Position the fuse block module and the body wire harness onto the dash panel as a unit.
  2. Install and tighten the two screws that secure the fuse block module to the bracket on the dash panel. Tighten the screws to 3.3 N.m (30 in. lbs.).
  3. Engage each of the retainers that secure the body wire harness to the vehicle body and chassis components. Refer to appropriate wiring diagrams for the location of the body wire harness retainer locations.
  4. Install all of the fasteners that secure each of the body wire harness ground eyelets to the vehicle body and chassis components. Refer to appropriate wiring diagrams for the location of the body wire harness ground eyelet locations.
  5. Reconnect each of the body wire harness connectors. Refer to appropriate wiring diagrams for the location of the body wire harness connector locations.
  6. Install the instrument panel assembly onto the dash panel.
  7. Reconnect the battery negative cable.
· About lemon-mirror