lemon-mirror:
Home >> Jeep >> 2005 >> Wrangler X, Automatic >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Front >> Lower Control Arm >> Installation

Lower Control Arm: Installation

  1. Position the lower suspension arm in the axle bracket and frame rail bracket.
    NOTE: Small holes in the side of the arm face inboard.
  2. Install the rear bolt and nut finger tighten.
  3. Install bolt/cam bolt and new nut finger tighten in the axle and align the reference marks.
  4. If equipped with ABS brakes install sensor wire to the inboard side of the arm with new clips.
  5. Lower the vehicle.
  6. Tighten axle bracket nut to 176 N.m (130 ft. lbs.).
  7. Tighten frame bracket nut to 176 N.m (130 ft. lbs.).
  8. Align vehicle to specifications. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
· About lemon-mirror