Ignition Switch

Fig 1: Key Lock Cylinder Removal/Installation

Courtesy of CHRYSLER LLC

Install ignition key into lock cylinder (1). Rotate key to "ON" position (retaining tab on side of lock cylinder (3) can now be depressed).
The shaft at end of key lock cylinder aligns with socket within end of housing. To align socket with lock cylinder, ensure socket is in "ON" position.
Position and align key lock cylinder with grooves in housing.

Fig 2: Key Cylinder Release Tab
Courtesy of CHRYSLER LLC
Slide lock cylinder into housing until release tab (3) sticks through opening at side of housing.

Fig 3: Ignition Switch Mounting Screw
Courtesy of CHRYSLER LLC
Install ignition switch (2) to switch housing (1) until it snaps into the two tabs. Install and tighten screw (4).

Fig 4: SKREEM Mounting Screw
Courtesy of CHRYSLER LLC
Install SKREEM unit (2) to switch housing (3) and install screw (1).

Fig 5: Cable Removal Tabs Rear
Courtesy of CHRYSLER LLC
Position cable into assembly until tab (1) engages.

Fig 6: Ignition Switch Housing Top Screw
Courtesy of CHRYSLER LLC
Install one key cylinder housing Torx screw (1). Do not tighten (finger tight only).

Fig 7: Ignition Switch Housing Front Screws
Courtesy of CHRYSLER LLC
Install two key cylinder housing Torx screws (2). Now tighten all three housing mounting screws.
Install knee blocker. Refer to INSTALLATION .
Install silencer pad.
Install both bezel. Snaps on. Refer to INSTALLATION .
Connect negative battery cable.