SWITCH, Ignition: Installation: Installation

NOTE: The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before installing ignition switch.

Fig 1: Ignition Switch

Courtesy of CHRYSLER LLC

1 - Ignition Switch

2 - Ignition Switch Mounting Screws

1. Before installing ignition switch, rotate the slot in the switch to the ON position.
2. Connect the electrical connector to rear of the ignition switch. Make sure that locking tabs are fully seated into wiring connector.
3. Position switch (1) to column and install the mounting screws (2). Tighten screw to 3 N.m (26 in. lbs.).
   Fig 2: Ignition Switch With Tilt

   Courtesy of CHRYSLER LLC

   1 - IGNITION SWITCH

   2 - TILT LEVER MECHANISM

4. Install the tilt lever bracket (2) mounting screws. Tighten screws to 4.5 N.m (40 in. lbs.).
   Fig 3: Ignition Switch Without Tilt

   Courtesy of CHRYSLER LLC

   1 - Ignition Switch Mounting Screws

   2 - Non-Tilt Mounting Bracket Screws

5. If the column is non-tilt install the bracket. Tighten screws (2) to 4.5 N.m (40 in. lbs.).
   Fig 4: STEERING COLUMN

   Courtesy of CHRYSLER LLC

   1 - KEY CYLINDER

   2 - GEAR SHIFT LEVER

   3 - MOUNTING HOLES

   4 - STEERING COLUMN

   5 - IGNITION SWITCH

6. Position the wire retainer into the tilt lever bracket.
7. Reconnect the lower clockspring connectors.
8. Install the key cylinder (1)
9. Install steering column upper and lower shrouds.
10. Enable the airbag system. Refer to Restraints/AIR BAG, Driver - Installation .