lemon-mirror:
Home >> Jeep >> 2021 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Cooling System >> Engine >> Fan, Cooling >> Removal >> 3.0L Diesel

3.0L Diesel

CAUTION:

Care must be used when trying to remove the upper and lower shroud covers. Damaging the holes in the cover may cause it to become loose and not perform properly.

  1. Disconnect and isolate the negative battery cable.
    GC0146436Courtesy of CHRYSLER GROUP, LLC
  2. Remove the engine cover (1).
    GC0146809Courtesy of CHRYSLER GROUP, LLC
  3. Loosen the clamps (2), remove the Charge Air Cooler (CAC) hoses from the resonator and position the hoses aside.
  4. Remove the bolts (1) and remove the resonator and bracket as an assembly.
  5. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Remove the front skid plate. Refer to REMOVAL .
    GC0172168Courtesy of CHRYSLER GROUP, LLC
  7. Remove the lower cooling fan closeout panel (1).
  8. Remove the support and lower the vehicle.
    GC0145993Courtesy of CHRYSLER GROUP, LLC
  9. Remove the upper fan shroud cover (1) by using a pick (3) to pull the cover retaining hole away from the clip (2).
    GC0172161Courtesy of CHRYSLER GROUP, LLC
  10. Disconnect the cooling fan wire harness connector (1).
    GC0172139Courtesy of CHRYSLER GROUP, LLC
  11. Release both retaining tabs (1) and pull up to remove the cooling fan assembly from the top side of the engine compartment.
· About lemon-mirror