lemon-mirror:
Home >> Jeep >> 2021 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Cooling System >> Engine >> Pump, Water >> Removal >> 6.2L

Pump, Water: Removal: 6.2L

  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the front skid plate. Refer to REMOVAL .
  4. Drain the cooling system. Refer to DRAINING  .
  5. Remove the air cleaner body. Refer to REMOVAL .
  6. Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
  7. Remove the supercharger belt. Refer to BELT, DRIVE, REMOVAL .
  8. Disconnect the Engine Coolant Temperature (ECT) sensor wire harness connector.
    GC0180916Courtesy of CHRYSLER GROUP, LLC
  9. Remove the bolt (2) and the heater tube (1) from the water pump.
    GC0170066Courtesy of CHRYSLER GROUP, LLC
  10. Remove the bolt (1) and the idler pulley (2). Refer to PULLEY, IDLER, REMOVAL .
  11. Remove the bolt (1) and the belt tensioner assembly (2). Refer to TENSIONER, BELT, REMOVAL .
    GC0180919Courtesy of CHRYSLER GROUP, LLC
  12. Remove the upper radiator hose from the thermostat housing (1) and position aside.
  13. Remove the lower radiator hose from the water pump (3) and position aside.
  14. Remove the upper stud bolt.
  15. Remove the water pump mounting bolts (2) and carefully remove the pump (3).
· About lemon-mirror