Fuse Arrays: Notes

REMOVAL 

Upper Fuse Array 

1. Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT - DUAL 12 VOLT BATTERY SYSTEM, 3.0L or BATTERY DISCONNECT AND CONNECT - SINGLE 12V BATTERY SYSTEM, 5.7L & 6.4L or BATTERY DISCONNECT AND CONNECT - ETORQUE SYSTEM, 5.7L & 6.4L .

   Courtesy of CHRYSLER GROUP, LLC

   1 - Latches

   2 - Power Distribution Cover

2. Remove the front Power Distribution Center (PDC) cover by pushing inward on the latches and lifting up on the PDC cover.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Eyelet Nuts

   2 - Eyelets

   3 - Power Distribution Center (PDC)

3. Remove the eyelet nuts and disconnect the eyelets from the PDC.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Upper Fuse Array

   2 - Power Distribution Center (PDC)

4. Release the retaining tab that secures the fuse array to the PDC and lift up on the upper fuse array to remove it from the PDC.

   Lower Fuse Array 

   Courtesy of CHRYSLER GROUP, LLC

   1 - Tabs

   2 - PDC Bolts

   3 - Power Distribution Center

5. Loosen the PDC bolts.
   NOTE:

   The PDC bolts are captured and cannot be removed from the PDC.

6. Release the tabs on the sides of the PDC and lift upward to remove the PDC from the PDC bracket.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Eyelet Nuts

   2 - Eyelets

   3 - Wire Harness Connectors

   4 - PDC Bracket

7. Remove the eyelet nuts and disconnect the eyelets from the PDC bracket.

   Courtesy of CHRYSLER GROUP, LLC

   1 - Fuse Array Nuts

   2 - Lower Fuse Array

   3 - Power Distribution Center Bracket

8. Remove the lower fuse array nuts and remove the lower fuse array from the PDC bracket.

INSTALLATION 

Follow the removal procedure in reverse for general reassembly of the components on the vehicle.