Right Hand Drive: Notes

REMOVAL

WARNING:

Before servicing the steering column the airbag system must be disarmed. Failure to do so may result in accidental deployment of the airbag and possible personal injury.

WARNING:

When an undeployed airbag module is to be removed from the vehicle, first disconnect the battery ground cable and isolate it. Allow the system capacitor to discharge for a minimum of two minutes before starting any removal.

CAUTION:

Anytime the Steering Column Control Module (SCCM) is mounted on the steering column the steering shaft must be kept from turning or else SCCM damage will occur. Some vehicles do not have an internal lock mechanisms, so the steering column shaft must be preventing from rotating through use of a suitable tool.

Remove the steering wheel. Refer to WHEEL, STEERING, REMOVAL AND INSTALLATION .
Remove and DISCARD the intermediate shaft pinch bolt.

Courtesy of CHRYSLER GROUP, LLC

1 - Intermediate Shaft Pinch Bolt
Disengage the intermediate shaft from the steering column shaft.
Remove the interior Power Distribution Center (PDC). Refer to CENTER, POWER DISTRIBUTION (PDC), REMOVAL AND INSTALLATION .
Remove the steering column shroud. Refer to SHROUD, STEERING COLUMN, REMOVAL AND INSTALLATION .
Remove the SCCM. Refer to MODULE, STEERING COLUMN CONTROL (SCCM), REMOVAL AND INSTALLATION .
If equipped, disconnect the steering column motor wire harness connectors.

Courtesy of CHRYSLER GROUP, LLC

1 - Wire Harness Connector

2 - Wire Harness Connector
Disconnect the wire harness routing clip.

Courtesy of CHRYSLER GROUP, LLC

1 - Wire Harness Routing Clip
Disconnect the Comfort Steering Wheel Surface Module (CSWSM) wire harness connector.

Courtesy of CHRYSLER GROUP, LLC

1 - Wire Harness Connector
Disengage the wire harness routing clip.

Courtesy of CHRYSLER GROUP, LLC

1 - Wire Harness Routing Clip
Remove the steering column nuts and lower the steering column.

Courtesy of CHRYSLER GROUP, LLC

1 - Steering Column Nuts
If equipped, disconnect the Electronic Steering Lock (ESL) module wire harness connector.

Courtesy of CHRYSLER GROUP, LLC

1 - Wire Harness Connector

2 - Electronic Steering Lock (ESL) Module Bolts
Pull the steering column shaft through bulkhead pass through and remove the steering column.
Remove the CSWSM screws and remove the CSWSM from the steering column.

Courtesy of CHRYSLER GROUP, LLC

1 - Comfort Steering Wheel Surface Module (CSWSM) Screws
If equipped, remove the ESL module. Refer to MODULE, ELECTRONIC STEERING LOCK (ESL), REMOVAL AND INSTALLATION .

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle.