Road Test
- Drive vehicle with gearshift lever in "OD" position, and allow transaxle to reach normal operating temperature. Check minimum throttle upshifts in Overdrive. Transaxle should start in 1st gear, shift to 2nd, 3rd, and 4th gear at approximate speeds shown in FA4A-EL SHIFT SPEEDS tables under FA4A-EL SHIFT SPEEDS.
- With transaxle in 4th gear (Overdrive), press Transmission Control Switch (TCS), if equipped. Transaxle should downshift to 3rd gear. Release accelerator pedal. Engine braking should occur.
- Press accelerator pedal to WOT. Transaxle should shift from 3rd to 2nd gear, or 3rd to 1st gear depending on vehicle speed. Torque converter clutch should disengage, and then reapply.
- With transaxle in "OD" position, and vehicle speed is less than 68 MPH with half throttle, move gearshift lever to manual "2" position. Release accelerator pedal. Transaxle should immediately downshift to 2nd gear. Move gearshift lever to manual "1" position. Transaxle should downshift to 1st gear at speeds less than 27 MPH.
- If transaxle fails to operate normally or torque converter does not apply and release properly, diagnose problem by symptom. See SYMPTOM DIAGNOSIS under TROUBLE SHOOTING.