Charging System: Alternator: Reassembly

NOTE: Be careful not to get any grease or oil on the slip rings.

Insert the rotor (A) in the stator and front frame assembly (B).

Fig 1: Identifying Rotor And Frame Assembly
Courtesy of KIA MOTORS AMERICA, INC.
Install the washer (B) and the rear bracket assembly (A)

Fig 2: Identifying Rear Bracket Assembly And Washer
Courtesy of KIA MOTORS AMERICA, INC.
Tighten the four nuts (A) and insulators (B).

Fig 3: Identifying Nuts
Courtesy of KIA MOTORS AMERICA, INC.

Fig 4: Identifying Insulators
Courtesy of KIA MOTORS AMERICA, INC.
Install the rectifier (B) and the rubber seal (C) by tightening the four screws.

Fig 5: Identifying Rectifier And Rubber Seal With Screws
Courtesy of KIA MOTORS AMERICA, INC.
Install the brush holder (A).

Fig 6: Identifying Brush Holder
Courtesy of KIA MOTORS AMERICA, INC.
Install the generator cover (A) by tightening the three nuts (B).

Fig 7: Identifying Generator Cover And Nuts
Courtesy of KIA MOTORS AMERICA, INC.
Install the pulley with a hexagonal wrench.