lemon-mirror:
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis >> Electrical >> Body Electrical >> Body Electrical System >> Immobilizer Control System >> DTC P1675 Transponder Programming Error >> Monitor DTC Status

Monitor DTC Status

  1. Connect scantool to Data Link Connector (DLC)
  2. Ignition "ON" & engine "OFF"
  3. Select "Diagnostic Trouble Codes (DTCs)" mode and monitor "DTC Status" parameter
  4. Is the DTC B1675 present?

    YES 

    Go to "COMPONENT INSPECTION " procedure.

    NO 

    Fault is intermittent caused by poor contact in SMARTRA's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

· About lemon-mirror