Module Assembly Replacement

Remove the following parts.
1. Door trim.
2. Door screen.
3. Window Glass.
4. Outside handle
Loosen the mounting screw (A).
Tightening torque:

0.7~0.5N.m (0.07~0.1kgf.m, 1.0~0.7 lb-ft)

Fig 1: Identifying Module Assembly Mounting Screw
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the rod (A).

Fig 2: Identifying Module Assembly Rod
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting bolt and nut, then remove the rear channel (A).

Fig 3: Identifying Rear Channel, Mounting Bolt And Nut
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the door module mounting bolts, remove the door module (A).
Detach the clips, then remove the wiring harness.
Tightening torque:

7.8~11.8N.m (0.8~1.2kgf.m, 5.8~8.7 lb-ft)

Fig 4: Identifying Door Module
Courtesy of KIA MOTORS AMERICA, INC.
Installation is the reverse of removal.
NOTE:
- The area of whole parts should be applied with sufficient grease.
- Make sure the connector is plugged in properly and each rod is connected securely.
- Make sure the door lock and open proper