Repair Procedures: Removal: Notes

NOTE:

Be careful not to damage the fuel line during repair.

CAUTION: In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don't do any repair work right after engine stops.

[Low pressure fuel line]

Turn the ignition switch OFF, and then remove battery (-) cable.
Release the residual pressure in fuel line.
(Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE .")
Remove the fuel tank.
(Refer to "FUEL TANK .")
Open the low pressure fuel tube clip (A).

Courtesy of
Release the low pressure fuel quick-connector (A) using the clip remover (B).

Courtesy of

NOTE: When removing the low pressure fuel quick-connector, use a clip remover as shown in the image below.

Courtesy of
Disconnect the vapor hose (A) and low pressure fuel quick-connector (B).

Courtesy of
Lift the vehicle.
Remove the under cover LH (A).

Courtesy of
Remove the under cover RH (A).

Courtesy of
Remove the front muffler mounting nuts (A)

Courtesy of
Remove the center muffler and rear muffler.
Remove the rear heat protector (A).

Courtesy of
Remove the front heat protector (A).

Courtesy of
Remove the low pressure fuel tube clamp mounting nut (A).
Fuel tube clamp mounting nut:

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Courtesy of
Unclip the fuel feed tube (A) and vapor tube (B) holders using a flat-head screwdriver.

Courtesy of
Open the holder (A)

Courtesy of
Remove the fuel line (A) from the vehicle,

Courtesy of

Courtesy of