Repair Procedures: Replacement

CAUTION:

Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
Exercise caution in order to minimize the length and frequency of contact of your skin to used oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use waterless hand cleaner, to remove any used engine oil. Do not use gasoline, thinners, or solvents.
In order to preserve the environment, used oil and used oil filter must be disposed of only at designated disposal sites.

Park the car on level ground.
Drain engine oil.
1. Remove the oil filler cap (A).
  
  Fig 1: Locating Oil Filler Cap
  Courtesy of KIA MOTORS AMERICA, INC.
2. After lifting the car, remove the oil drain plug (A) and drain oil into a container.
  
  Fig 2: Locating Oil Drain Plug
  Courtesy of KIA MOTORS AMERICA, INC.
Replace the oil filter.
1. Remove the oil filter cap (A).
  
  Fig 3: Locating Oil Filter Cap, O-Ring & Oil Filter Element
  Courtesy of KIA MOTORS AMERICA, INC.
2. Replace the O-ring (B) of oil filter cap with a new one.
3. Replace the new oil filter element (C).
4. Check and clean the oil filter installation surface.
5. Apply clean engine oil to the new O-rings (B).
6. Lightly screw the oil filter cap (A) into place, and tighten it until the O-ring (B) contacts the seat.
  NOTE: Check the O-ring (A) so that it is installed correctly inside the cap.
  
  Fig 4: Locating O-Ring
  Courtesy of KIA MOTORS AMERICA, INC.
7. Finally tighten it again to the specified tightening torque.
Fill new engine oil.
1. Install the oil drain plug (A) with a new gasket.
  Tightening torque:
  
  34.3 ~ 44.1N.m (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)
  
  Fig 5: Locating Oil Drain Plug
  Courtesy of KIA MOTORS AMERICA, INC.
2. Fill with new engine oil while checking the oil level on the dipstick.
  Capacity
  
  Total: 6.5 L (6.87 US qt, 5.72 lmp qt, 1.72 US.gal)
  
  Oil pan: 6.0 L (6.34 US qt, 5.28 lmp qt, 1.58 US.gal)
  
  Drain and refill including oil filter:
  
  5.7 L (6.02 US qt, 5.01 lmp qt, 1.50 US.gal)
  NOTE:
  - Fill the crankcase to about half the capacity and then fill the remainder after waiting.
  - Do not fill oil over the "F" line and check frequently the level with the oil level gauge to ensure no overfilling.
3. Install the oil filler cap and the oil dipstick.
Start the engine and check that no oil is leaking from the drain plug or oil filter.
Recheck the engine oil level.
NOTE: When rechecking the engine oil level, be sure to warm up the engine enough. If the engine is not warmed up sufficiently, the measurement of the engine oil level may be less than the specification.
To reset the service interval to the recommended mileage, refer to the appropriate service information or refer to the owner's manual for procedure (if applicable).