lemon-mirror:
Home >> Land Rover >> 1999 >> Discovery SD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock >> Bleeding Brake System >> Bleeding Procedures >> Brake System

Brake System

  1. Turn ignition off and disconnect negative battery cable. Ensure brake fluid level in reservoir stays between the MIN and MAX levels. Thoroughly clean caliper bleeder screws before attaching bleed hose.
  2. Attach bleed hose to any caliper bleeder screw. Submerge other end of bleed hose in clean glass jar partially filled with clean brake fluid. Open bleeder screw. Using full, even strokes, slowly depress brake pedal several times until there are no air bubbles in jar.
  3. Depress and hold brake pedal down, and close bleeder screw. Release brake pedal. Repeat procedure on remaining calipers. Tighten bleeder screws to specification. See TORQUE SPECIFICATIONS  . Install bleeder screw protector caps. Check brake fluid level in reservoir. See CHECKING BRAKE FLUID LEVEL  . Reconnect negative battery cable.
· About lemon-mirror