Combination Meter: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE STEERING COLUMN COVER UPPER (See REMOVAL )
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Using a screwdriver, detach the 5 clips.
  HINT:
  
  Tape the screwdriver tip before use.
2. Remove the cluster finish panel and then disconnect the connector.
  
  Fig 1: Identifying Cluster Finish Panel
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COMBINATION METER ASSEMBLY
1. Remove the 4 screws.
2. Disconnect the connector and remove the combination meter.
  
  Fig 2: Locating Combination Meter And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COMBINATION METER GLASS
1. Using a screwdriver, detach the 2 claws and open the cover.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 3: Locating Combination Meter Glass Cover And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the 3 connectors.
  
  Fig 4: Locating Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the combination meter glass's wire harness with the clamps.
  
  Fig 5: Identifying Combination Meter Glass Wire Harness With Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Detach the 7 claws and remove the glass.
  
  Fig 6: Identifying Claws Location
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002