Charging Systems: Charging: Generator: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE FRONT WHEEL RH
REMOVE NO. 1 ENGINE UNDER COVER
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
REMOVE FRONT FENDER APRON SEAL RH
REMOVE ENGINE ROOM COVER SIDE (See REMOVAL )
REMOVE V-BANK COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
REMOVE NO. 2 AIR CLEANER INLET (See REMOVAL )
REMOVE AIR CLEANER CAP SUB-ASSEMBLY (See REMOVAL )
REMOVE NO. 1 AIR CLEANER INLET (See REMOVAL )
DISCONNECT RADIATOR RESERVOIR TANK HOSE (See REMOVAL )
REMOVE HOOD LOCK CONTROL CABLE COVER (See REMOVAL )
REMOVE HOOD LOCK ASSEMBLY (See REMOVAL )
REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY (See REMOVAL )
REMOVE FAN SHROUD (See REMOVAL )
REMOVE V-RIBBED BELT (See REMOVAL )
REMOVE GENERATOR ASSEMBLY
1. Remove the terminal cap.
2. Remove the nut and disconnect the wire harness from terminal B.
3. Disconnect the generator connector from the generator assembly.
  
  Fig 1: Identifying Generator Connector & Generator Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disconnect the connector from the compressor and magnetic clutch.
5. Disconnect the 2 wire harness clamps.
6. Remove the 2 bolts.
  
  Fig 2: Identifying Generator Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Remove the bolt from the cylinder block.
  
  Fig 3: Identifying Cylinder Block Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Disconnect the wire harness clamp and remove the generator assembly.
9. Remove the bolt and wire harness clamp stay.
  
  Fig 4: Identifying Wire Harness Clamp Stay Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Remove the bolt and bracket.
  
  Fig 5: Identifying Bolt & Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002