Rear Console Box: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See SPECIFIED TORQUE FOR STANDARD BOLTS ).

Fig 1: Identifying Rear Console Armrest Assembly Screws

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. INSTALL CONSOLE BOX 
   1. Connect the connector.
   2. Install the console box with the 4 bolts and 2 screws.
      Fig 2: Identifying Console Box Bolts And Screws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL CONSOLE BOX REGISTER ASSEMBLY 
   1. Attach the 4 clips to install the register.
      Fig 3: Identifying Console Box Register Assembly Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL CONSOLE BOX PLATE 
   1. Connect the connector.
   2. Attach the 4 clips to install the console box plate.
      Fig 4: Identifying Console Box Plate Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH 
   1. Attach the 4 clips and 3 claws to install the finish panel end.
   2. Install the screw.
      Fig 5: Identifying Instrument Panel Finish Panel End LH Claws And Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH 
   1. Attach the 3 clips and 3 claws to install the finish panel end.
   2. Install the screw.
      Fig 6: Identifying Finish Panel End Clips And Claws

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. INSTALL CONSOLE UPPER PANEL ASSEMBLY 
   1. Connect the connector.
   2. Attach the 9 clips to install the ash receptacle.
      Fig 7: Identifying Console Upper Panel Assembly Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Install the shift lever knob and turn it in the direction indicated by the arrow.
7. INSTALL FRONT CONSOLE UPPER PANEL GARNISH 
   1. Attach the claws to install the garnish.
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
9. PERFORM INITIALIZATION 
   Fig 8: Installing Shift Lever Knob

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE: Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.

   Perform initialization (See INITIALIZATION ).

10. INSPECT SRS WARNING LIGHT 

    Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).