Inspection Procedure

1. Disconnect the L13 connector.
2. Measure the voltage and resistance according to the value (s) in the table below.

   Voltage 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Condition	Specified Condition
   L13-12 (BDR) -Body ground	Always	10 to 14 V

   Resistance 

   TESTER CONNECTION SPECIFIED CONDITION
   
   

   Tester Connection	Condition	Specified Condition
   L13-7 (GND) -Body ground	Always	Below 1 Ω

Fig 1: Identifying L13 Connector Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE