lemon-mirror:
Home >> Lexus >> 2008 >> IS 350 >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel (2GR-FSE) >> Injector Driver >> Installation

Injector Driver: Installation

  1. INSTALL INJECTOR DRIVER 
    1. Install the injector driver with the bolt and 2 nuts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      NOTE:
      • Be careful not to drop or strike the injector driver.
      • The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.
      Fig 1: Locating Injector Driver Bolt And Nuts
      G05826375Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the 3 connectors with wire harness locks and the connector to the injector driver. Move the lock lever in the direction indicated by the arrow to lock the connector.
  2. INSTALL NO. 1 ENGINE COVER  (See INSTALLATION )
  3. INSTALL NO. 1 INLET AIR CLEANER  (See INSTALLATION )
  4. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
Fig 2: Locating Connectors With Wire Harness Locks
G05826377Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
· About lemon-mirror