lemon-mirror:
Home >> Lincoln >> 1983 >> Continental Base >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless Entry System >> Testing >> Pinpoint Test B Keypad Illumination >> Test Procedures

Test Procedures

  1. Check for at least 10 volts between ground and pins 13 and 14 of Green connector, then pin 13 of Brown connector. If voltage is 10V or more, go to next step. If not, repair circuits or replace fuses and retest.
  2. Check for continuity to ground between pins 5 and 6 of Green connector, then pin 2 of Brown connector. If okay, go to next step. If no continuity is measured, repair broken circuits and retest.
  3. Disconnect keypad and Brown connector. Check for continuity between pin 1 of Brown connector and ground. If continuity is found, repair circuit 66 and retest. If not, go too next step.
  4. Connect keypad. Check resistance between pin 1 of Brown connector and ground. If less than 10 ohms, go to Pinpoint Test C. If more than 10 ohms, go to next step.
  5. Disconnect keypad, then measure resistance between pins 8 and 11 of keypad connector. If more than 10 ohms, replace keypad and retest. If under 10 ohms, go to next step.
  6. Disconnect module Brown connector and keypad connector. Check continuity between Brown connector pin 1 and keypad connector pin 8. If circuit 66 is open, repair wiring and retest. If okay, go to next step.
  7. Check for continuity between keypad harness connector pin 11 and ground. If continuity is present, go to the next step. If not, repair wiring and retest.
  8. Check for short between pin 12 and Brown connector and ground. If shorted circuit 124, repair and retest. If not, go to next step.
  9. Check continuity between Brown connector pin 12 and keypad connector pin 10. If continuity is found, replace module and retest. If no continuity, repair wiring and retest.
· About lemon-mirror