lemon-mirror:
Home >> Lincoln >> 2006 >> LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine >> In-Vehicle Repair >> Oil Cooler >> Installation

Oil Cooler: Installation

    NOTE: Inspect the gasket and surfaces for contamination prior to installation. Lubricate the gasket with clean engine oil.
  1. Position the oil cooler and a new gasket and install the bolt.
    • Rotate the cooler clockwise until the locating pin hits the stop.
    • Tighten the bolt to 60 Nm (44 lb-ft).
    2. NOTE: Lubricate the gasket with clean engine oil.
  2. Install a new oil filter and gasket until the seal makes contact.
    • Using an oil filter strap wrench, tighten the filter an additional 270 degrees.
  3. Connect the 2 coolant hoses to the oil cooler.
  4. Fill the engine with clean engine oil.
    5. CAUTION: The cooling system filling and bleeding procedure must be followed exactly or damage to the engine can occur.
  5. Fill and bleed the engine cooling system. For additional information, refer to ENGINE COOLING .
· About lemon-mirror