Compressor Driver Module
- Remove the rear floor console refrigerator. Refer to Refrigerator .
-
Using a long thin screwdriver, remove the phillips screw from the compressor driver module mounting bracket.
- Disconnect the upper electrical connector from the compressor driver module.
- Rotate the compressor driver module to the right and remove from the mounting bracket.
- Disconnect the lower electrical connector from the compressor driver module.
- Disconnect the compressor driver module-to-refrigerator electrical connector.
- To install, reverse the removal procedure.
NOTE:
Do not bend the condenser tubes. The screwdriver must fit between the condenser tubes or damage may occur to the refrigerator.