Alarm Stop Phase
Unlock any door or trunk with key.
NOTE:
If system does not operate as previously described, use the following procedure to determine where to begin testing.
- Open any door window. Close all doors. Remove ignition key. With hood and trunk closed, open any door. If security light comes on and buzzer sounds once, go to next step. If security light does not come on and buzzer does not sound, go to TEST NO. 1. If buzzer sounds but security light does not come on, go to TEST NO. 2. If security light comes on but buzzer does not sound, go to TEST NO. 3.
- With all doors locked, security light should stay lit for 10 seconds. After 10 seconds, buzzer should sound once then security light should flash every 3 seconds. If security light and buzzer respond as specified, go to next step. If buzzer does not sound or security light does not flash, go to TEST NO. 4.
- Turn ignition on. If security light does not go out, go to TEST NO. 5. If security light goes out, go to next step.
- Perform steps 1) and 2) to set arming condition. Unlock any door lock knob. Security light should go out, horn should sound and headlights and hazard lights should flash. Starter should not operate when trying to start engine. If results are as specified, go to next step. If results are not as specified, go to appropriate test.
- If security light does not go out, go to TEST NO. 6.
- If horn does not sound, go to TEST NO. 7.
- If headlights do not flash, go to TEST NO. 8.
- If hazard lights do not flash, go to TEST NO. 9.
- If starter operates, go to TEST NO. 10.
- Using key, unlock any door key cylinder, or open trunk lid. Warning should cancel (horn should stop sounding, headlights and hazard lights should stop flashing and starter should operate).
- If warning cancels when door and rear hatch are unlocked, go to next step.
- If warning does not cancel when door is unlocked but cancels when rear hatch is unlocked, go to TEST NO. 11.
- If warning does not cancel when rear hatch is unlocked but cancels when door is unlocked, go to TEST NO. 12.
- Remove STOP and HEAD fuses. Perform steps 1), 2) and 3). If headlights and hazard lights do not flash, go to TEST NO. 13. If headlights and hazard lights do not stop flashing after about 5 minutes, go to TEST NO. 14.