lemon-mirror:
Home >> Mazda >> 1995 >> 929 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System >> System Testing >> System Operation >> Alarm Stop Phase

Alarm Stop Phase

Unlock any door or trunk with key.

NOTE: If system does not operate as previously described, use the following procedure to determine where to begin testing.
  1. Open any door window. Close all doors. Remove ignition key. With hood and trunk closed, open any door. If security light illuminates and buzzer sounds once, go to next step. If security light does not illuminate and buzzer does not sound, go to TEST NO. 1 under SYSTEM DIAGNOSTIC TESTS  . If security light does not illuminate but buzzer sounds, go to TEST NO. 2. If security light illuminates but buzzer does not sound, go to TEST NO. 3.
  2. With all doors locked, security light should stay lit for 10 seconds. After 10 seconds, buzzer should sound once then security light should flash every 3 seconds. If security light and buzzer respond as specified, go to next step. If buzzer does not sound or security light does not flash, go to TEST NO. 4.
  3. Turn ignition on. If security light does not go out, go to TEST NO. 5. If security light goes out, go to next step.
  4. Perform steps 1) and 2) to set arming condition. Unlock any door lock knob. Security light should go out, horn should sound, and headlights and hazard lights should flash. Starter should not operate when trying to start engine. If results are as specified, go to next step. If results are not as specified, go to appropriate test.
    • If security light does not go out, go to TEST NO. 6.
    • If horn does not sound, go to TEST NO. 7.
    • If headlights do not flash, go to TEST NO. 8.
    • If hazard lights do not flash, go to TEST NO. 9.
    • If starter operates, go to TEST NO. 10.
  5. Using key, unlock any door key cylinder, or open trunk. Warning should cancel (horn should stop sounding, headlights and hazard lights should stop flashing and starter should operate).
    • If warning cancels when door and trunk key cylinders are unlocked, go to next step.
    • If warning does not cancel when door key cylinder is unlocked, go to TEST NO. 11.
    • If warning does not cancel when trunk key cylinder is unlocked, go to TEST NO. 12.
  6. Remove STOP fuse (20-amp) and HEAD fuse (40-amp). Perform steps 1), 2) and 3). If hazard lights do not flash for 2-3 minutes, or do not stop flashing after about 2-3 minutes, go to TEST NO. 13.
· About lemon-mirror