Filament Repair

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

Use isopropyl alcohol to clean around the damaged section of the filament.
Attach tape above and below the damaged section of the filament.
Using a small brush or marking pen, repair the filament with silver paint or equivalent.
After approximately 2-3 minutes , carefully remove the tape without disturbing the repaired area.
CAUTION:
- Do not use the rear window defroster until the paint is completely dry. It may cause other malfunctions if it is used before the paint is dry.
Fig 1: Repairing Filament
Courtesy of MAZDA MOTORS CORP.
Use a hot air blower heated to 150°C {302°F} for 30 minutes or let the paint set for 24 hours at 25°C {77°F} to allow it to dry completely.