lemon-mirror:
Home >> Mazda >> 2002 >> MPV ES >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Fuel System) >> Fuel Injector Removal/Installation >> Notes

Fuel Injector Removal/Installation: Notes

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Complete the "BEFORE REPAIR PROCEDURE". (See BEFORE REPAIR PROCEDURE .)
  2. Disconnect the negative battery cable.
  3. Remove the dynamic chamber. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  4. Disconnect the fuel injector connectors and remove the harness from the fuel distributor.
  5. Remove in the order indicated in the table.
    Fig 1: Removing/Installing Sequence Order Of Fuel Injector
    G00991564Courtesy of MAZDA MOTORS CORP.
    Fig 2: Removing/Installing Fuel Injector
    G00991565Courtesy of MAZDA MOTORS CORP.
    CAUTION:
    • Disconnecting/connecting the quick release connector without cleaning it may possibly cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.
  6. Install in the reverse order of removal.
  7. Complete the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE .)
· About lemon-mirror