Filament Repair
- Clean the filament using isopropyl alcohol.
- Attach tape to both sides of the filament.
Courtesy of MAZDA MOTORS CORP.
- Using a small brush or marking pen, apply silver paint.
- After 2-3 min,
carefully remove the tape without damaging the applied area.
CAUTION:
- Do not operate the rear window defroster until the paint is completely dry. It may be cause other malfunctions if it is used before paint is dry.
- Dry the repaired part using the following procedure.
- When the room temperature is 25°C {77°F},
leave as it is for 24 h.
- When a hot air blower is used, dry with the temperature of 150°C {302°F}
for 30 min.