Pcm Replacement
- Connect the WDS or equivalent to the DLC-2.
- Set up the WDS or equivalent (including the vehicle recognition).
- Select "Module Programming".
- Select "Programmable Module Installation".
- Select "PCM" and perform procedures according to directions on the WDS or equivalent screen.
Courtesy of MAZDA MOTORS CORP.
NOTE:
- If the PCM is replaced with a new one, the PCM stores DTC P0602 and illuminates the MIL even though no malfunction is detected. When the configuration is completed, DTC P0602 is cleared.
- Retrieve DTC's by the WDS or equivalent, then verify that there in no DTC present.
- If DTC is present, perform applicable DTC inspection. (See
DTC TABLE
).