lemon-mirror:
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System (L3 With TC) >> Fuel Injector Removal/Installation >> Notes

Fuel Injector Removal/Installation: Notes

CAUTION:
  • Disconnecting/connecting the quick release connector without cleaning it may cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.
NOTE:
  • When the fuel pressure sensor replaces, replace a new fuel delivery pipe with a new fuel pressure sensor. 01-14B-25 FUEL INJECTOR REMOVAL/INSTALLATION [L3 WITH TC]
  1. Complete the "BEFORE REPAIR PROCEDURE". See BEFORE REPAIR PROCEDURE .
  2. Disconnect the negative battery cable.
  3. Remove the intake manifold. See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .
  4. Remove in the order indicated in the table.
    Fig 1: Identifying Removal Order Of Fuel Injector
    G04324898Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
  6. Complete the "AFTER REPAIR PROCEDURE". See AFTER REPAIR PROCEDURE .
· About lemon-mirror