Pcm Configuration

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS or equivalent to the DLC-2.

Fig 1: Locating DLC-2 Connector

Courtesy of MAZDA MOTORS CORP.

Set up the M-MDS or equivalent (including the vehicle recognition).
Select "Module Programming".
Select "Programmable Module Installation".
Select "PCM" and perform procedures according to directions on the M-MDS or equivalent screen.
NOTE:
- If the PCM is replaced with a new one, the PCM stores DTC P0602 and illuminates the MIL even though no malfunction is detected. This means the PCM has not been configured yet.
Retrieve DTC's by the M-MDS or equivalent, then verify that there in no DTC present.
- If DTC is present, perform applicable DTC inspection. (See DTC TABLE .)