Continuity Inspection

Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION [G35M-R] .)
Verify that the continuity between neutral switch terminals A and B is as indicated in the table.
- If there is no malfunction, perform the "Circuit Open/Short Inspection".
- If there is any malfunction, replace the neutral switch.
  
  Fig 1: Inspecting Neutral Switch
  Courtesy of MAZDA MOTORS CORP.

MEASURED CONDITION AND CONTINUITY REFERENCE

Measured condition	Transmission	Continuity
Rod pushed	In neutral	Continuity detected
Except above	Other	No continuity