OBD-II Drive Mode: Notes
- Using the OBD-II drive mode, the monitoring item requested by OBD-II regulations can be easily diagnosed.
- Performing the Drive Mode inspects the OBD-II system for proper operation and must be performed to ensure that no additional DTCs are present.
- The OBD-II drive mode is divided into the specific drive mode and single drive mode.
- For the specific drive mode, specified drive modes have been set for each individual monitoring item requested by OBD-II regulations, and they can be diagnosed individually. For the single drive mode, the entire monitoring item requested by OBD-II regulations can be diagnosed.
- The following modes are in the specific drive mode. The applicable system is diagnosed by driving in the following drive modes.
- Mode 3 (A/F sensor heater, HO2S heater, A/F sensor, HO2S, and TWC Repair Verification Drive Mode)
- Mode 5 (AIR System Repair Verification Drive Mode)
- Mode 6 (EVAP System Repair Verification Drive Mode)
- The following systems are diagnosed with the single drive mode.
- A/F sensor heater, HO2S heater
- A/F sensor, HO2S
- TWC
- AIR System
- EVAP System
CAUTION:
- While performing the Drive Mode, always operate the vehicle in a safe and lawful manner.
- When the M-MDS is used to observe monitor system status while driving, be sure to have another technician with you, or record the data in the M-MDS using the PID/DATA MONITOR AND RECORD function and inspect later.
NOTE:
- Vehicle speed and engine speed detected by the PCM may differ from that indicated by the speedometer and tachometer. Use the M-MDS to monitor vehicle speed and engine speed.
- If the OBD-II system inspection is not completed during the Drive Mode, the following causes are considered:
- The OBD-II system detected a malfunction.
- The Drive Mode procedure was not completed correctly.
- Disconnecting the battery will reset the memory. Do not disconnect the battery during and after the Drive Mode.
- The M-MDS can be used at anytime through the course of the Drive Mode to monitor the completion status. Monitoring can be done by viewing the ON BOARD SYSTEM READINESS menu.
- The RFC diagnostic status can be confirmed with the ignition switch operation. During KOEO, the MIL illuminates for a fail-light inspection for approx. 17 s.
The RFC diagnostic status is confirmed after the fail-light inspection.
- If all of the RFC diagnostic is completed even one time, the MIL will continue to illuminate.
- If all of the RFC diagnostic is not completed, the MIL flashes for approx. 7 s, and then it illuminates until the engine is started.