lemon-mirror:
Home >> Mazda >> 2011 >> RX-8 R3, 1.3 4 >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control System >> Front Abs Wheel-Speed Sensor Inspection >> Sensor Output Value Inspection

Sensor Output Value Inspection

CAUTION:
  • Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed sensor.
  1. Turn the ignition switch off.
  2. Connect the M-MDS to the DLC-2.
  3. Select the following PIDs using the M-MDS:
    • LF_WSPD

      (LF wheel-speed sensor)

    • RF_WSPD

      (RF wheel-speed sensor)

  4. Start the engine and drive the vehicle.
  5. Verify that the display of the M-MDS shows the same value as the speedometer.
    • If there is any malfunction, replace the front ABS wheel-speed sensor.
    Fig 1: Identifying DLC-2 Connector
    G05985092Courtesy of MAZDA MOTORS CORP.
· About lemon-mirror