Two-step down function Inspection

NOTE:

Before inspecting the two-step down function, make sure that the two-step down function is turned on.
The two-step down position is adjustable within 20-100 mm {0.79-3.94 in} .
The two-step down function does not operate while the IG-OFF timer function is activated.

STEP	INSPECTION		ACTION
1	Switch the ignition ON. Fully close the driver-side power window. Open the power window using the manual open/close function on the power window main switch. Verify that the power window stops 30 mm {1.2 in} lower than the fully closed position for 1 s . Does power window operate properly? NOTE: While the auto open/close function is activated, the two-step down function does not operate.	Yes	Two-step down function is normal.
1		No	Verify that the auto open/close function operates properly. If the auto open/close function operates properly: Verify that the two-step down function is turned on. If the auto open/close function does not operate properly: Replace the power window main switch (power window control unit is malfunctioning.)(See POWER WINDOW MAIN SWITCH REMOVAL/INSTALLATION .)