Keyless Receiver Inspection: Notes
- Remove the following parts:
- Rear scuff plate (LH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
- Sub-trunk (See SUB-TRUNK REMOVAL/INSTALLATION .)
- Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
- Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
- Third-row seat belt lower anchor installation bolt (LH) (See THIRD-ROW SEAT BELT REMOVAL/INSTALLATION .)
- Trunk side trim (LH) (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
- Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltages cannot be verified as indicated in the terminal voltage table, inspect the parts under "Inspection item(s)".
- If the system does not operate normally even though the parts under "Inspection Item(s)" and related wiring harnesses do not have any malfunction, replace the keyless receiver.
- If the voltages cannot be verified as indicated in the terminal voltage table, inspect the parts under "Inspection item(s)".