lemon-mirror:
Home >> Mazda >> 2016 >> CX-9 Signature >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (Service Information) >> Initial Learning >> Not Using of M-MDS >> Preparation before servicing

Preparation before servicing

  1. Verify initial learning implementation necessity for replacement parts.
    Replacement part Initial learning necessity
    Control valve body replacement Necessary
    Oil pressure switch replacement Necessary
    Clutches(1) Necessary
    Automatic transaxle replacement Necessary
    ON/OFF solenoid replacement Unnecessary
    Coupler component replacement Unnecessary
    (1) Low clutch, high clutch, R-3-5 brake, 2-6 brake, and low and reverse brake
  2. Apply the parking brake firmly, and set the wheel blocks for both the front and rear wheels.
  3. Inspect the ATF level. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [GW6A-EL, GW6AX-EL] .)
  4. Start the engine.
  5. Warm-up the engine and allow the ATF temperature to reach 60-110 °C {140-230 °F}  .
· About lemon-mirror