Load Compensation Inspection

Start the engine and let it idle.
Connect the M-MDS to the DLC-2.
Verify that DTC P0506:00 or P0507:00 is not displayed. (See ON-BOARD DIAGNOSTIC TEST .)
- If DTC P0506:00 or P0507:00 is displayed, perform the DTC inspection. (See DTC P0506:00, P151B:00 [PCM (SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION))] .) (See DTC P0507:00 [PCM (SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION))] .)
Select the RPM PID.
NOTE:
- Excludes temporary idle speed drop just after the loads are turned on.
Verify that the engine speed is within specification under each load condition.
- If the load condition is not as specified, inspect the following:
  - A/C switch and related wiring harness system (A/C request signal is always on or off) (See NO. 23 A/C DOES NOT WORK SUFFICIENTLY .) (See NO. 24 A/C IS ALWAYS ON OR A/C COMPRESSOR RUNS CONTINUOUSLY .)
  - Electrical load
  - Charging system (See BATTERY INSPECTION .) (See GENERATOR INSPECTION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)] .)
    Idle-up speed (P, N position)
    
    No load: 600-700 rpm
    
    A/C on: 650-800 rpm
    
    Electrical loads on: 600-750 rpm