Indicator Removal/Installation: Notes

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
2. Remove the following parts.
   1. Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION .)
   2. Switch panel (See SWITCH PANEL REMOVAL/INSTALLATION .)
   3. Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION .)
   4. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
3. Turn over the removed shift panel and remove the boots from the boots securing parts shown in the figure.
   Fig 1: Removing Boots From Boots Securing Parts

   Courtesy of MAZDA MOTORS CORP.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.

Fig 2: Indicator Components

Courtesy of MAZDA MOTORS CORP.

COMPONENT DESCRIPTION

1	Indicator connector
2	Drive selection switch connector (With drive selection switch)
3	Screw (With drive selection switch)
4	Drive selection switch (With drive selection switch)
5	Indicator panel
6	Indicator (See INDICATOR REMOVAL NOTE .)