Load compensation inspection

Start the engine and let it idle.
Connect the M-MDS to the DLC-2.
Select the RPM PID.
NOTE:
- Excludes temporary idle speed drop just after the loads are turned on.
Verify that the engine speed is within specification under each load condition.

If the load condition is not as specified, inspect the following:
- A/C switch and related wiring harness system (A/C request signal is always on or off) (See NO. 23 A/C DOES NOT WORK SUFFICIENTLY ). (See NO. 24 A/C IS ALWAYS ON OR A/C COMPRESSOR RUNS CONTINUOUSLY ).
- Electrical load
- Charging system (See BATTERY INSPECTION ). (See GENERATOR INSPECTION (SKYACTIV-G 2.0) ).
  Idle-up speed (MT: Neutral position, AT: P, N position)
  
  No load: 660-760 RPM (MT), 670-770 RPM (AT)
  
  A/C on (With A/C): 720-870 RPM (MT), 700-800 RPM (AT)
  
  Electrical loads on: 680-780 RPM (MT), 690-790 RPM (AT)