lemon-mirror:
Home >> Mazda >> 2021 >> 6 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Entertainment System) >> Condenser Removal/Installation

Condenser Removal/Installation

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Rear scuff plate (LH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Rear seat cushion (LH) (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
    3. Rear side seat back (LH) (See REAR SEAT BACK REMOVAL/INSTALLATION .)
    4. Tire house trim (LH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    5. C-pillar trim (LH) (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
  3. Disconnect the connector.
    Fig 1: Condenser, C-Pillar (LH), Connector And Bolt With Torque Specification
    G09788380Courtesy of MAZDA MOTORS CORP.
  4. Remove the bolt.
  5. Remove the condenser.
  6. Install in the reverse order of removal.
· About lemon-mirror