Total Toe-In Adjustment
WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the locknut of the tie-rod end.
- Remove the boot clamp.
- Adjust the total toe-in by rotating each tie rod (left and right) in the opposite directions by the same amount respectively.NOTE:
- Toe angle changes by Aprox. 7 mm {0.3 in} in per one rotation of the tie rod for one wheel.
- Each tie rod has a right-hand thread.
- Tighten the locknut of the tie-rod end.
Tightening Torque
- 69-98 N.m {7.1-9.9 kgf.m, 51-72 ft.lbf}
- Verify that the boot does not have any twisting and install the boot clamp.