lemon-mirror:
Home >> Mazda >> 2021 >> CX-9 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Security And Locks) >> LF Control Unit Removal/Installation

LF Control Unit Removal/Installation

WARNING: This page is about a different car, the 2017 Mazda CX-9. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the service hole cover on the front side trim.
    Fig 1: Service Hole Cover On Front Side Trim
    G11432739Courtesy of MAZDA MOTORS CORP.
  3. Disconnect the connector.
    Fig 2: LF Control Unit Connector
    G11432740Courtesy of MAZDA MOTORS CORP.
  4. Pull the LF control unit in the direction of the arrow (2) shown in the figure and remove it while pressing the tab in the direction of the arrow (1).
    Fig 3: Pulling LF Control Unit
    G11432741Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
· About lemon-mirror