TCM Configuration
NOTE:
- The TCM is built into the control valve body.
- Verify TCM configuration implementation necessity for replacement parts.
Replacement part Configuration necessity Control valve body replacement Necessary Oil pressure switch replacement Unnecessary Automatic transaxle replacement Necessary ON/OFF solenoid replacement Unnecessary Coupler component replacement Unnecessary - Connect the M-MDS to the DLC-2.
- After vehicle identification, the following can be selected from the M-MDS initialization screen.
- Select "Module Programming".
- Then, select the following from the screen menu.
- Select "Programmable Module Installation".
- Select "TCM".
- Perform the configuration following the instructions on the screen.
- Verify that no DTCs are stored. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (GW6A-EL, GW6AX-EL)]
.)NOTE:
- If any DTC (U code) is output, the system is normal.
- Delete the U code and verify that no DTC is output. (See ON-BOARD DIAGNOSTIC SYSTEM DTC INSPECTION [TCM (GW6A-EL, GW6AX-EL)]
.)
- If any DTC other than U code is output, repair the malfunctioning location according to the applicable DTC troubleshooting. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (GW6A-EL, GW6AX-EL)] .)