Drive Selection Switch Removal/Installation : Notes

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
2. Remove the selector lever knob. (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION .)
3. Remove the shift panel component. (See SHIFT PANEL REMOVAL/INSTALLATION .)
4. Remove the upper panel. (See UPPER PANEL REMOVAL/INSTALLATION .)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.

Courtesy of MAZDA MOTORS CORP.

COMPONENT OPERATIONS

Component no.	Refer to
1	Screw
2	Drive selection switch (See DRIVE SELECTION SWITCH INSTALLATION NOTE .)