Generators & Regulators: Overhaul: Reassembly
- Install bearing, retainer, and screws in front housing. Press rotor onto housing. Press bearing on slip ring end of rotor. Solder stator to diode assembly. Exercise care when soldering near diodes due to possible heat damage.
- Install insulators on stator assembly. Assemble stator assembly and rear housing. Install wave washer or "O" ring in rear housing. Align scribe marks and assemble front and rear housings.
- Install key, fan assembly, and spacers. Install pulley, lock washer, and nut. Tighten nut to 23-29 ft. lbs. (3-4 N.m). Ensure that rotor spins freely. Install voltage regulator and capacitor.
ALTERNATOR APPLICATION
| Model |
Volts/Amps |
Part No. |
| 190D |
14/70 |
489 897 |
| 190E |
14/70 |
489 928 |
| 300D, CD, SD & TD |
14/65 |
489 935 |
| 380 SL |
14/70 |
489 897 |
| 380 SE, 500SEC & 500SEL |
14/80 |
489 588 |