Service Precautions

WARNING: Some models are equipped with Supplemental Restraint System (SRS). To avoid injury from accidental air bag deployment, read and carefully follow all WARNINGS and SERVICE PRECAUTIONS before performing ANY repair. Failure to follow air bag precautions may result in air bag deployment and personal injury. Refer to SERVICE PRECAUTIONS as well as DISABLING & ACTIVATING AIR BAG SYSTEM in the see AIR BAG RESTRAINT SYSTEM article in the ACCESSORIES/ SAFETY EQUIP Section.

CAUTION: For information on disabling or activating the air bag system, see AIR BAG RESTRAINT SYSTEM article in the ACCESSORIES/SAFETY EQUIP Section.

NOTE: For information on air bag DIAGNOSIS & TESTING or DISPOSAL PROCEDURES, see AIR BAG RESTRAINT SYSTEM article in the ACCESSORIES/SAFETY EQUIP Section.

Observe the following precautions when working with air bag systems:

When working around steering column components, and before any repairs are performed, disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM. Failure to do this could result in accidental air bag deployment and possible personal injury.
After an air bag deployment, air bag surface may contain deposits of sodium hydroxide, which irritates skin. Always wear safety glasses, rubber gloves and long-sleeved shirt during clean-up. Wash hands using mild soap and water. Follow correct air bag disposal procedures.
After completing repairs, turn ignition on from passenger side of vehicle just in case of accidental air bag deployment. Ensure SRS indicator light is working properly and no system faults are indicated. See SYSTEM OPERATION CHECK in the AIR BAG RESTRAINT SYSTEM article.
NEVER activate or apply power to SRS system if air bag module or any sensor is not rigidly attached to the vehicle.
To avoid air bag deployment when trouble shooting near SRS system, NEVER use battery-powered test equipment, such as battery powered or AC powered test light, voltmeter, ohmmeter, etc.
No repairs should be performed to any part of SRS wiring harness.
Always carry air bag module with trim cover away from body. Always place module on workbench with trim cover up, away from loose objects.
DO NOT expose any SRS system components to temperatures in excess of 212°F (100°C).
DO NOT expose any SRS system components to cleaning agents such as solvents, gasoline, lye, etc.