lemon-mirror:
Home >> Mercedes Benz >> 2001 >> ML430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Disc) >> Bleeding Brake System >> Bleeding Procedure >> Procedure B

Procedure B

WARNING: This page does not describe the selected car, but rather 29 other vehicles, including the 2000 Mercedes-Benz SLK230, 2000 Mercedes-Benz SL500, 2000 Mercedes-Benz S500, 2000 Mercedes-Benz S430, and 2000 Mercedes-Benz ML55. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Connect pressure bleeding equipment according to equipment manufacturer's instructions and pressurize system to 29 psi (2 bar). Connect Hand Held Tester (HHT) to Data Link Connector (DLC) located in right rear of engine compartment. Turn ignition on. Follow instructions on HHT display. After performing instructions on HHT display, start bleeding procedure.
  2. Caliper bleeding sequence is RR, LR, RF and LF. Bleed approximately 1/10th of a quart of brake fluid from each brake caliper. Allow brake fluid to flow until no air bubbles are present. Remove pressure bleeding equipment and HHT. Verify master cylinder reservoir is at proper level.
· About lemon-mirror