lemon-mirror:
Home >> Mercedes Benz >> 2012 >> CL600 >> Repair and Diagnosis >> General Information >> Reset Procedures >> ATEQ TPMS Reset Procedure >> ATEQ TPMS Reset Procedure

ATEQ TPMS Reset Procedure

NOTE: Mercedes refers to this procedure as TPMS Restart.
  1. Check and set tire pressure on all four tires.
  2. Make sure that the SmartKey is in POSITION 2 in the ignition lock.
  3. Press left or right arrow button on the multifunction steering wheel to select the SERVICE menu.
  4. Press up or down arrow button on the multifunction steering wheel to select TIRE PRESSURE.
  5. Press OK button. The current inflation pressure for each tire appears in the multifunction display or the following message appears in the multifunction display: TIRE PRESSURES WILL BE DISPLAYED AFTER DRIVING A FEW MINUTES.
  6. Press down arrow button. The following message appears in the multifunction display: USE CURRENT PRESSURES AS NEW REFERENCE VALUES.
  7. Press OK button to comfirm reset. The following message appears in the multifunction display: TIRE PRESS. MONITOR RESTARTED.

After driving a few minutes the system verifies that the current tire inflation pressures are within the system's specified range. Afterwards the current tire inflation pressures are accepted as reference values and then monitored.

NOTE: When the wheel positions have been changed, the inflation pressure of a tire may be displayed for the wrong position temporarily. After driving for a few minutes, the inflation pressure will be shown for the correct position.
· About lemon-mirror